Skip to content
Precision metal Phillips-head screws (part number SFM2X4) designed to fasten internal housing components with the KUPA UP-200/UG12 handpiece series.

UP-200 Screw SFM2X4

by Ovation Spas
$3.00 - $3.00
$3.00
$3.00 - $3.00
$3.00

This metal Phillips-head screw (part number SFM2X4) designed for use in the KUPA UP-200 / UG12 handpiece series. These screws are used to secure internal components or housings within the handpiece, and are critical for maintaining structural integrity and alignment.

Features

  • Ensures correct fastening and internal structural hold-down in your UP-200 / UG12 handpiece — critical for high-speed, precision operation.

  • Using the correct OEM screw set helps maintain correct tolerances and avoids improper fitment or vibration issues from incorrect screws.

  • Cost-effective maintenance — a small part but can prevent larger issues caused by loose or missing fasteners.

  • Dimensions:

    • Length (including head): ~3.77 mm. 

    • Thread size: ~1/64″. 

    • Head size: ~2.94 mm. 

  • Material: Metal (standard replacement material for high-speed handpiece internal fasteners).

Installation Tips

  • Confirm your handpiece revision uses this exact screw set (SFM2X4). Handpiece internal revisions may vary fastener types.

  • Inspect the existing screw holes and mating surfaces for damage, stripping, or wear — replacing screws alone may not fully restore structural integrity if threads or housings are damaged.

  1. Disconnect the handpiece from power and ensure it is fully stopped before disassembly.

  2. Remove the appropriate housing or access panel where these screws are located.

  3. Remove the old screws and clean any debris or metal shavings from the screw holes.

  4. Insert the new SFM2X4 screws, ensuring correct orientation, depth and that they seat flush. Use the proper driver to avoid stripping.

  5. Reassemble the handpiece and test under no-load (no bit) at low speed to verify smooth operation and no unusual vibration before full use.