UP-200 Carbon Brush PKE-560

This is an OEM replacement set of carbon motor brushes (part number PKE‑560, often listed as PKE‑560A) for the KUPA UP‑200 / UG12 series handpieces. It comes in a 2‑piece pack and is designed to restore proper motor contact and performance, especially when the existing brushes are worn and the motor begins to sputter or lose power.

Features

• Application: Intended for UP‑200 / UG12 handpieces, used in the motor’s commutator section to ensure continuous electrical contact.

• Purpose: Replacing these brushes helps maintain smooth motor operation, full speed capability and reduces sparking or erratic behavior in the handpiece.

• OEM‑match: Using the correct part number ensures proper fit, correct material and compatibility — avoiding fitment issues or sub‑par performance that may occur with generic brushes.

Installation Tips

• Confirm that your handpiece uses brush set PKE‑560 (or PKE‑560A) — older or alternate revisions may use different brush part numbers.

• Inspect the current brushes for wear: typically they should have adequate length remaining and not be overly worn or damaged.

• Inspect the motor commutator and brush holder assembly: if these are damaged or excessively worn, simply installing new brushes may not completely restore performance.

1. Unplug the handpiece and ensure it is fully stopped before servicing.

2. Remove the motor housing or access cap to expose the brush holder assembly.

3. Remove the old brushes, noting their orientation and how the springs and terminals are positioned.

4. Insert the new brushes (PKE‑560), making sure the springs provide proper tension and that the brush face sits correctly on the commutator.

5. Re‑assemble the handpiece, plug it in, and run under no‑load (no bit) at low speed first to confirm smooth operation, minimal sparking and no abnormal noise or vibration.