Skip to content
Within the high-speed assembly of the handpiece, it serves as a thin spacer or shim between bearing surfaces, shaft/housing connections, or other comparable internal places.

UP-200 Metal Spacer KS-107

by Ovation Spas
$4.00 - $4.00
$4.00
$4.00 - $4.00
$4.00

This spacer is an OEM replacement component specified for the KUPA UP-200 / UG12 handpiece series. It functions as a thin shim/spacer inside the handpiece’s high-speed assembly—such as between bearing surfaces, shaft/housing junctions or similar internal locations—to maintain precise clearance and alignment.

Features

  • Maintains correct internal spacing in the handpiece, which helps ensure smooth rotation, minimal vibration, and proper bearing/housing alignment.

  • Helps reduce wear on adjacent components (bearings, shafts, housings) by maintaining designed clearances.

  • Cost-efficient maintenance part: replacing this shim during servicing can restore performance without replacing larger assemblies.

  • OEM specified: ensures correct dimensions and material for the intended handpiece model.

  • Dimensions: ID ~3.5 mm · OD ~10 mm · Thickness ~0.2 mm

  • Material: Copper, suited for “high‐speed” environments

Installation Tips

  • Confirm that your handpiece uses the KS-107 spacer (check parts list or existing spacer).

  • Inspect the seating surfaces and adjacent components for wear or damage—if the housing or shaft is worn, simply installing a new spacer may not fully restore optimal performance.

  1. Disconnect and power off the handpiece; ensure it is fully stopped.

  2. Disassemble the relevant section (e.g., front housing or spindle area) to access where the spacer sits.

  3. Remove the old spacer, clean the area of any debris or metal shavings.

  4. Insert the new KS-107 spacer, making sure it lies flat and is correctly seated.

  5. Re-assemble the handpiece and perform a no-load test (with no bit installed) at low speed to verify smooth operation and minimal vibration before full operational use.