Skip to content
OEM replacement housing Version 102 (#KP55-01) for KUPA KP-55 handpiece. Metal body shell Ø ≈ 20 mm × length ≈ 71.26 mm, designed to restore structural alignment and performance in the Professional KP-55 nail-drill handpiece.

KP-55A Housing KP5501

by Ovation Spas
$35.00 - $35.00
$35.00
$35.00 - $35.00
$35.00

This housing (version 102) is a full-body shell designed for the KUPA KP-55 handpiece. It replaces the outer metal housing of the handpiece, restoring structural integrity, proper internal alignment and original fit & finish.

Features

  • OEM designated “Housing Version 102 #KP55-01, Each” from KUPA’s parts list. 

  • Machined metal body, sized for the KP-55 handpiece internal assembly (Ø ~20 mm, Length ~71.26 mm). 

  • Designed to restore original alignment of front-end components (spindle, bearings, collet) when housing is worn, scratched or damaged.

Installation Tips

  • Confirm that your handpiece is indeed the KP-55 version that uses the Version 102 housing (older or variant models might have different housing part numbers).

  • Check that the existing housing dimensions match roughly: ~20 mm diameter and ~71.26 mm length.

  • When replacing the housing, inspect all internals: bearings, seals, shaft, collet. A new housing alone may not solve performance issues if other parts are worn.

  • Disconnect and power off the handpiece prior to disassembly.

  • Remove the front nose, collet chuck and unscrew the old housing or open the body as needed.

  • Transfer or reinstall all internal components into the new housing with care—ensure clean surfaces, correct orientation and proper mounting.

  • Re-assemble the handpiece, then test unloaded (no bit) at low speed to verify smooth operation, proper alignment and absence of vibration before full use.